View Single Post
Old 03-12-2010, 05:46 PM   #4
n4xyz
Junior Member
 
Join Date: Mar 2008
Posts: 9
Default Rv antenna feed thru

Thanks for the reply's. We have Laredo with a rear living area. The ladder is on the right rear corner. Just inside is a corner cabinet with a TV in the middle and cabinet on top and below. I wanted to mount an AH-4 antenna tuner (wire tuner) in the lower cabinet. The bottom of the trailer in covered with a membrane that I really don't like cutting into but it might be the best. I would like to drill two holes (one for antenna wire and one for the ground) on the back wall behind the ladder. I was thinking of the ceramic feedthrus. I just need to make it water tight. I don't think there is any metal in the wall so I might be able to use two pieces of all thread with large washers against the two surfaces. I was thinking of doing something similar with an SO-239 for 2m. Just use a large washer or a 2x2 inch aluminum plate inside and out with plenty of caulk. The operating position is close to the corner cabinet on a TV tray table That is what I have been struggling with.

Thanks again, Dave
__________________
Dave & Kay
N4XYZ & KE4TCH
2008 Duramax CC/LB
2014 Grand Design
Reflection 303RLS
n4xyz is offline   Reply With Quote