Open Roads Radio forum for Ham, Amateur Radio and RV camping


Reply
 
Thread Tools Display Modes
 
Old 11-21-2007, 11:43 AM   #1
KEJF
Junior Member
 
Join Date: Nov 2007
Location: Littleton, CO (Denver)
Posts: 1
Default What antenna(s) do you use?

The title says it all.
I am experimenting with a screwdriver, but use HamStixs most of the time.
When camped for a while, I often use a random length of wire thrown over a tree and a tuner. Boy I can't wait for the Solar cycle to start swinging up!
I also want to hear from any users of verticals, tilt-up, or what have you?
My current mobile rig is an Icom 706Mk II G. I plan to some day go full-time and then move the base rig, Kenwood TS2000, to the RV.

73 de Jerry,
KEJF
KEJF is offline   Reply With Quote
Old 11-21-2007, 12:22 PM   #2
radiow6lar
Member
 
Join Date: Nov 2007
Location: Southern California
Posts: 44
Default What I'm using now.

We have an 2006 Aljo 225LT for our present RV. I set about to get the usual stuff put together for mobile ham radio ops when we first bought it. I settled on a High Sierra 1800 for the antenna system. As I certainly don't operate while in motion I placed the mount at the top of the rear ladder. When we are stopped I just climb the ladder and drop the 1800 in place.

I ran the coax and power out through the refer cabinet. So far its working really well.

On this issue I got to tell you I have one very understanding and supportive XYL. She's a Ham too but thats another story. The control cable and coax connector are mounted on the lower face of the bench seat for our dining area. The radio/laptop/etc. goes right on the table and the radio connects to the bulkhead coax connector. Its really nice to "tune" the antenna when its 30 degrees outside or raining from the comfort of a nice warm RV.

Performance wise so far its been pretty good. I did have to add some capacitance to the base of the antenna mount when operating on 80M.

I run an IC-718 in the RV and have an IC-706 MKII with a High Sierra SideKick on my TV. Also use VHF/UHF and 6M so I do have two smaller antennas on the TV along with the SideKick.
__________________
Larry, W6LAR and Helen, KF6CHG
Me, Retired May 2009.
Helen, retired Aug 2009
2004 F-150 XL Supercab HD
2006 Aljo 225LT, Solar Powered
Me: 43 1/2 years GTE (Verizon)
Wife: RN and 45 years putting up with Me!

CQ CQ CQ Ain't life Grand!
radiow6lar is offline   Reply With Quote
Old 11-21-2007, 01:07 PM   #3
AE5BI
Senior Member
 
AE5BI's Avatar
 
Join Date: Nov 2007
Location: Pleasant Hill, CA
Posts: 104
Default

I am running an Astatic AST 6BTV HF Portable Antenna 4 band (10, 15, 20 & 40 or 80 meter). I picked it up at our local Hamfest. It is not very flat on each band so basically you have to pick a frequency, tune the antenna to that frequency and you are stuck with it. Not very good for contesting but I don't do that anyway. I also use the TS-2000.

I intend to come up with some other antenna solution in the future and I look forward to the ideas that show up on this thread.
__________________
2000 Monaco Knight 36Z
- Kenwood TS-2000
- SG237 Tuner & Long Wire

2006 Jeep (X2)
- iCom IC-706MKIIG
- AH-4 Automatic Antenna Tuner to a 102" Radio Shack CB antenna

Guinness the cat

Full-timing Sep. 2006 - Sep. 2011

Our RV Website, www.FulltimeRV.us

73

AE5BI
AE5BI is offline   Reply With Quote
Old 11-21-2007, 03:08 PM   #4
Radio
Administrator
 
Radio's Avatar
 
Join Date: Nov 2007
Location: Fayetteville, GA, USA
Posts: 3,004
Default

When I do island hopping I use a homemade 20m bazooka and a beat up old Butternut vertical someone gave me. The Butternut breaks down pretty well and that bazooka will work the world at 30 feet up!

Radio
Radio is offline   Reply With Quote
Old 11-21-2007, 05:50 PM   #5
Richard Stouffer
Senior Member
 
Join Date: Nov 2007
Posts: 188
Default

I've rigged an MFJ fiberglass mast to the ladder. It tops out around 35 feet. I run about 38 feet of 16 guage wrapped around the mast. An Icom AH-4 tuner is at the base of the mast. I get decent results with an Icom 7000. It is a bit of a fuss to set up, but it does get me on the air. It also attracks a lot of attention.

I set up the radio in the main cabin slide at the dining table and had the dealer run the cables through the raceway under the slide. I'm using 213 coax and it took them almost 8 hours to install it. Now my problem is grounding, both DC and RF. My motorhome is fiberglass on an aluminum frame. I've popped the GFI a couple of times running the 7000 barefoot. I'll probalby have to take a copper rod along and stick it in the ground and run a braided cable to it. Next trip will be to Florida at Christmas and I'll try doing that when I'm there.

Richard, WU5K
Richard Stouffer is offline   Reply With Quote
Old 11-22-2007, 07:07 AM   #6
wd8ovl
Junior Member
 
Join Date: Nov 2007
Location: East Lansing, MI
Posts: 5
Default

While in motoin I use hamsticks. While parked for a few days I use a Hustler 5 band
verticle mounted to ball hitch and slid into the receiver of the MH. I have rigged up
a ground from the frame to the ball hitch, works very well.

Ben
wd8ovl
wd8ovl is offline   Reply With Quote
Old 11-22-2007, 09:13 PM   #7
wa8yxm
Senior Member
 
Join Date: Nov 2007
Location: Mobile, on the road
Posts: 1,139
Send a message via AIM to wa8yxm Send a message via Yahoo to wa8yxm Send a message via Skype™ to wa8yxm
Default

I am still Experimenting (I like playing with antennas) In Motion I am currently not using anything I can not drive and work HF at the same time. (VHF I have a Diamond dual band)
Parked I have a hustler 40-10 Trap Vertical I've never used, plan on installing it when next time I go camping, I have a CB whip which the KAT-1 will load on 80 meters, I have about 25 feet of copper pipe with a CB whip on top (around 35 electrical feet) again the KAT-1 Tuner loves it. I have a few lengths of wire (25-100 foot) and can even string them together (And the KAT again feed them)

I plan on putting a six meter vertical INSIDE the rear cap (Fiberglass cap) and possibly using it mobile.

I plan on putting a railing along the side of the roof.. (Copper pipe to the KAT)
wa8yxm is offline   Reply With Quote
Old 11-25-2007, 01:55 PM   #8
twotrips
Junior Member
 
Join Date: Nov 2007
Location: Collinsville,Illinois - Metro St.Louis Area
Posts: 2
Default

On the road I use a 2 meter radio on 146.52. Next time I go out I am gonna start calling CQ on 52, I think we are all listening instead of talking.. On the TT I use a Outbacker Outpost with a Outbacker Outreach on it. It does okay. If we are at a place were I can get a wire up, I carry 3 wire antennas, a G5RV, an 80 meter dipole, and a 40 meter dipole, they work great. I had my dealer run 2 coax cables to a panel on the outside of the TT before we brought it home. I made the cables up and he installed them for me, did a real nice job. So now I have on the side of the trailer, cable tv/sat tv hook up and 2 antenna hook ups, looks real good.
Alan
ka9ryp
twotrips is offline   Reply With Quote
Old 11-25-2007, 08:04 PM   #9
wa8yxm
Senior Member
 
Join Date: Nov 2007
Location: Mobile, on the road
Posts: 1,139
Send a message via AIM to wa8yxm Send a message via Yahoo to wa8yxm Send a message via Skype™ to wa8yxm
Default

I put one of the standard stove vent hood vents in the side of my motor home next to where I mounted my TS-2000, I'm planing on doing a machined aluminum insert for it next summer (When I finish paying my body and metal man) with feed through fittings for at least half a dozen coax cables. 70-cm, (May use bnc for this one) 2-mtr (bnc or Pl-259) 6-mtr (PL-259) and "Other" (Have not decided what I'm going to hook to those, likely a G5RV JR to one of them) and a six position coax switch on ANT-2 inside, ANT-1 is the KAT-1 Random wire tuner on the back of the ride.

IF you notice that this is more switch positions than I'll have coax (The 2 mtr and 70cm antennas are different outputs on the TS-2000 you are right, the remaining 2 Switch positoins are 1: 6mtr verticle that's going UNDER the rear cap (False rear) and 2: Cantenna (A good old heath cantenna, Need to get me a gallon of oil though)

The cantenna is going in a box under the rig coax up through the floor to the switch, Same hole will carry the cable to the 6-mtr whip mounted on the frame at the rear. I have the antenna, just need to hook-'er up.
wa8yxm is offline   Reply With Quote
Old 11-27-2007, 10:02 PM   #10
TXiceman
Senior Member
 
TXiceman's Avatar
 
Join Date: Nov 2007
Location: Near Houston, TX
Posts: 553
Default

This will be helpful as I'm looking at ways to go mobile with the RV. I have seen a few that string up a G5RV and go. others with screwdrivers and all sorts of portable rigs.
Ken
KE5DFR
__________________
KE5DFR
2013 HitchHiker Champagne 38RLRSB, 2012 F350 Dually crew cab, 6.7L,
Mobile- Yaesu FT857D w/ Lil' Tarheel II antenna and Larsen dual bander, Turbo Tuner.
Base unit...Kenwood TS480HX, LDG AT200 Pro tuner, Eagle One Vertical and Windom 80 meter dipole.
Standard Schnauzer..her call is K9WOOF
TXiceman is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump

Powered by vBadvanced CMPS v3.2.3

All times are GMT -5. The time now is 06:29 PM.


Powered by vBulletin® Version 3.8.9
Copyright ©2000 - 2018, vBulletin Solutions, Inc.