Quote:
Originally Posted by Radio
Cut two pieces of 1/2" angle aluminum (Home Depot) slightly wider than the radio. Drill a hole for a long bolt at each end that would attach to the shelf. You have the option of bolting it up under a shelf or onto the top of a shelf. I would glue a thin rubber padding to avoid scratching the radio and to keep it from slipping.
|
Interesting. It set me thinking. Depending upon the width of the radio, you might go to an auto parts house and look at auto-battery clamps. These often are padded angles with a piece to tie them together at the top (across the top of the battery or radio) and a way to pass a bolt vertically down through the surface on which the battery (radio) rests.
For example:
BATTERY HOLD DOWN -- you might have to extend or shorten the rod that goes across.