View Single Post
Old 04-26-2015, 12:36 PM   #25
electricflyer
Senior Member
 
electricflyer's Avatar
 
Join Date: Jul 2013
Location: Douglasville, GA
Posts: 417
Default

Here is a repost of my radio go box. I added another photo that may be slightly better. I used 1/4" luan and used aluminum angle 3/4"x3/4" on the corners and to hold each shelf . The dimensions are 12"hx10"w11"d. I should have made it another inch wider and another inch deeper for a place to store the mic and jumper wires. I used power poles/sermos connectors for power which is what I also use for the deep cycle battery and the Astron power supply on my desk. The radio is a Yaesu FT-450, the tuner is a LDG AT-200pro and the power supply is a Radio Shack 25A switching power supply. I have a front and back panel that is held in place with threaded rod and wing nuts thru the tubes seen on each side of
the tuner. I would like to put a carry handle on the top but that would need to be reinforced before I do that as it may be a little heavy for 1/4" luan to hold.
P1010005.jpg

P1010001.jpg
electricflyer is offline   Reply With Quote