Sorry that I do not have any pics. I'll work on that. Setting up the wind gen. isn't to hard - I've built an "H" shaped frame that the mast attaches to in the middle. I pull the 20' mask up with the PU and then guy wire it to each corner of the "H". All of this is 1 1/4" black pipe that breaks down into 8' sections. Wiring runs from a slip ring (that the PMA runs into) down the outside of the pipe to the 100amp controller. The Controller has two 300w dump loads attached since a wind generator has to have a load on it at all times. This is hard to discribe. Guess I'd better work on pictures. I'll try to get some after we set up in December.
|